Textile analysis

There are a wide range of possible tests available. The following is a brief list of those most commonly used and undertaken in a UKAS accredited laboratory. If the specific test required is not given below, please contact us for further information.

There are several methods to determine fabric STRENGTH/DAMAGE depending upon the fabric fibre content.

• Cuprammonium fluidity (BS2610) for use on 100% cotton and certain cellulosic fibres to determine the level of chemical damage sustained on both new and used items.

  £70 per test

• Tear and Breaking strength – BSI EN ISO 13937 or BS EN ISO 13934 or BS 2576. Used for both 100% cotton and polyester cotton fabrics. There are a range of 7 types for this depending upon the fabric.

  £37.50 per test

FABRIC CONSTRUCTION becomes important when buying against a specification or validating the correct construction has been used.

• Martindale abrasion test – ISO 12947 to determine the risk of pilling and shade change caused by abrasion.

  £37.50 per test

• Terry loop tenacity – The pile extraction from a woven towel.

  £37.50 per specimen

• Picks and ends - BSI EN 1049-2 To determine the number of warp and weft threads in a fabric.

  £30 per sample

• Fibre Content BS EN ISO 1833 normally used on mixed fibre content, e.g. Polyester cotton, to determine the fabric composition.

  £52.50 per specimen

Please note: All prices quoted are excluding VAT which shall be applied at the rate applicable at the date of our invoice. All prices are subject to change without notice.

Bespoke Testing

LTC has developed several bespoke test procedures for specific issues including determining the potential for workwear garments to be contaminated with residual nut allergens and for simulating spontaneous combustion. If you have a specific requirement one of our consultants will assist you. Prices for this are based on the range and type of testing required.